Arduino - Remote control (RF-TX)

[Makso]

Nisam sad koristio interrupt.

Code:

int LED = 12;
int taster1 = 8;
int taster2 = 9;

void setup() {
 pinMode(LED, OUTPUT);
 pinMode(taster1, INPUT);
 pinMode(taster2, INPUT);
 Serial.begin(9600);
}

void loop() {
       if(digitalRead(8) == HIGH){
       digitalWrite(LED, HIGH);
       Serial.println(1111);
      }
      else{
       Serial.println(0000);
       digitalWrite(LED, LOW);
      }
      if(digitalRead(9) == HIGH){
       Serial.println(2222);
      }
      else{
       taster2test = 0;
       Serial.println(3333);
      }
      delay(20);
}

Prijem.

Code:

int ledPin = 13;
int ledPin2 = A1;

void setup() {
 Serial.begin(9600);
 pinMode(ledPin, OUTPUT);
 pinMode(ledPin2, OUTPUT);
}

void loop() {
 
 if(Serial.available() > 0){
   int input = Serial.parseInt();//read serial input and convert to integer (-32,768 to 32,767)    
   if(input == 1111){//if on code is received
     digitalWrite(ledPin, HIGH);//turn LED on
   }
   if(input == 0000){//if off code is received
     digitalWrite(ledPin, LOW);//turn LED off
   }
   if(input == 2222){
     digitalWrite(ledPin2, HIGH);
   }
   if(input == 3333){
     digitalWrite(ledPin2, LOW);
   }
 }
}

EDIT

Kada sam dodao interrupt sa onim dodacima stopiranja interrupt-a onda opet dobijam ono kašnjenje, tako da nisam dobro interrupt odradio.