DIY Electronic projects › Mikrokontroleri › Atmel
Razvoj, Dizajn CNC-Controller V1.0

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Razvoj, Dizajn CNC-Controller V1.0
ronovar Offline
Posting Freak
*****
Posts: 2.363
Threads: 79
Joined: Feb 2013
Reputation: 1.375
#48
08-03-2016, 09:03 AM
Radi ovako i to savršeno:

+5V i GND uzimam sa USB na Serijski adaptera a sa USBASP programatora sam spojio sve osim VCC i GND na ATmega328P...jer oba usb idu sa istog pc-a dakle vcc i gnd im je zajednicki. eXtreme Burner prepoznaje AVR read/write/erase/verify sve radi...pa ako bude ko kad ima slicni zahtjev da zna kako spojiti.
Reply


Messages In This Thread
Razvoj, Dizajn CNC-Controller V1.0 - by ronovar - 07-13-2016, 04:27 PM
RE: Razvoj, Dizajn CNC-Controller V1.0 - by nik - 07-15-2016, 11:23 AM
RE: Razvoj, Dizajn CNC-Controller V1.0 - by nik - 07-15-2016, 11:24 AM
RE: Razvoj, Dizajn CNC-Controller V1.0 - by ronovar - 08-03-2016, 09:03 AM

Forum Jump:


Users browsing this thread: 3 Guest(s)