Kenwood CS 4025
|
Kenwood CS 4025
|
 (08-19-2017, 09:11 AM)Vlada021 Wrote: Pitanje,čemu služi Output sa zadnje strane,nećemo ulaziti u z axis input.... Hvala Taj output verovatno neces nikad koristiti. Nije bilo skupo pa su postavili jedan konektor na kome imas, kao sto ti je Vladd rekao, izlazni signal sa prvog kanala. Z input sluzi za modulaciju mlaza po intezitetu, ne verujem da ces to ikada koristiti. Hm, skoro svi konektori sa zadnje strane se retko koriste.
Novac je sredstvo a ne cilj.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Kenwood CS 4025 - by Vlada021 - 08-18-2017, 08:40 AM
RE: Kenwood CS 4025 - by Gosha - 08-18-2017, 09:50 AM
RE: Kenwood CS 4025 - by Vlada021 - 08-18-2017, 09:53 AM
RE: Kenwood CS 4025 - by TDA - 08-18-2017, 03:58 PM
RE: Kenwood CS 4025 - by Vlada021 - 08-19-2017, 12:09 AM
RE: Kenwood CS 4025 - by Vlada021 - 08-19-2017, 09:11 AM
RE: Kenwood CS 4025 - by Gosha - 08-19-2017, 11:11 AM
RE: Kenwood CS 4025 - by vladd - 08-19-2017, 10:33 AM
RE: Kenwood CS 4025 - by Vlada021 - 08-19-2017, 10:52 AM
RE: Kenwood CS 4025 - by emiSAr - 08-19-2017, 11:29 AM
RE: Kenwood CS 4025 - by Vlada021 - 08-19-2017, 12:07 PM
RE: Kenwood CS 4025 - by vladd - 08-19-2017, 12:18 PM
RE: Kenwood CS 4025 - by Vlada021 - 08-19-2017, 12:27 PM
RE: Kenwood CS 4025 - by Macola - 08-19-2017, 03:45 PM
RE: Kenwood CS 4025 - by Macola - 08-19-2017, 04:37 PM
RE: Kenwood CS 4025 - by vladd - 08-19-2017, 04:55 PM
RE: Kenwood CS 4025 - by Macola - 08-19-2017, 07:02 PM
RE: Kenwood CS 4025 - by Vlada021 - 08-19-2017, 09:34 PM
RE: Kenwood CS 4025 - by vladd - 08-20-2017, 06:35 AM
|
