05-22-2023, 04:37 PM
Evo nakon malo istraživanja, evo potencijalnog rešenja za problem slabog toplotnog kapaciteta ručke 😀
Quote:Thanks very much for your review of the generic 936 "digital" and "analog" solder stations. The thermal capacity of these irons is a bit weak due to rather large diametric clearance between the tip and the heating element. This can be dramatically improved by wrapping a bit of aluminum kitchen foil around the heating element. Cut a piece about 30mm wide. Wrap it around the heating element and the tip-support sleeve, leaving a few mm hanging out past the end of the thermocouple. In my case, two turns did the trick. The bit of foil past the thermocouple will crush and fill the space to the tip. The foil improves the thermal conductivity between the heating element, the thermocouple and the tip. Now you can solder to large ground planes repeatedly without waiting for the iron to re-heat. Simple, quick and cheap fix.
Fray the strings
Throw the shapes
Hold your breath
And listen!
Throw the shapes
Hold your breath
And listen!