Pozdrav svima,
da li je neko imao slican problem.
PIC24FJ64GB002 mogu da programiram bez problema sa ICD3 ali ne mogu da debagujem
Device Erased...
Programming...
The following memory area(s) will be programmed:
program memory: start address = 0x0, end address = 0x21ff
configuration memory
Programming/Verify complete
The target device is not ready for debugging. Please check your configuration bit settings and program the device before proceeding. The most common causes for this failure are oscillator and/or PGC/PGD settings.
------------------------------------------------------------
Kao po obicaju bio je poblem sa PGC/PGD
Device Erased...
Programming...
The following memory area(s) will be programmed:
program memory: start address = 0x0, end address = 0x21ff
configuration memory
Programming/Verify complete
Running
da li je neko imao slican problem.
PIC24FJ64GB002 mogu da programiram bez problema sa ICD3 ali ne mogu da debagujem
Device Erased...
Programming...
The following memory area(s) will be programmed:
program memory: start address = 0x0, end address = 0x21ff
configuration memory
Programming/Verify complete
The target device is not ready for debugging. Please check your configuration bit settings and program the device before proceeding. The most common causes for this failure are oscillator and/or PGC/PGD settings.
------------------------------------------------------------
Kao po obicaju bio je poblem sa PGC/PGD
Device Erased...
Programming...
The following memory area(s) will be programmed:
program memory: start address = 0x0, end address = 0x21ff
configuration memory
Programming/Verify complete
Running