DIY Electronic projects › Merenja i merni uređaji - Measurements and Equipment › Merenja i merni uređaji - Measurements and Equipment v
CAN Bus

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
CAN Bus
vladd Offline
Senior Member
****
Posts: 624
Threads: 2
Joined: Aug 2014
Reputation: 193
#2
09-02-2018, 02:36 PM
Ne.
CAN jeste parcijalno standardizovan protokol, medjutim, svakom inzenjeru je ostavljena sloboda kodiranja infomacija u okviru paketa. Na CAN se prikljucuje uredjaj koji ce da sebi dodeli status mastera i da proziva komponente mreze.
Jedino da mu neko "jednostavno" doturi hakovan ili fabricki test jig.
Reply


Messages In This Thread
CAN Bus - by me[R]a - 09-02-2018, 02:16 PM
RE: CAN Bus - by vladd - 09-02-2018, 02:36 PM
RE: CAN Bus - by Аритон - 09-02-2018, 02:49 PM
RE: CAN Bus - by gorankg - 09-02-2018, 06:11 PM
RE: CAN Bus - by vsavic - 09-02-2018, 07:17 PM
RE: CAN Bus - by gorankg - 09-02-2018, 07:50 PM
RE: CAN Bus - by Аритон - 09-02-2018, 08:01 PM
RE: CAN Bus - by Аритон - 09-02-2018, 08:25 PM
RE: CAN Bus - by me[R]a - 09-02-2018, 08:58 PM
RE: CAN Bus - by vojinilic - 09-02-2018, 09:00 PM
RE: CAN Bus - by ZASto - 09-02-2018, 09:32 PM
RE: CAN Bus - by Аритон - 09-02-2018, 09:35 PM
RE: CAN Bus - by gorankg - 09-02-2018, 09:43 PM
RE: CAN Bus - by ZASto - 09-02-2018, 09:48 PM
RE: CAN Bus - by Аритон - 09-02-2018, 09:49 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)