Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
3D printing - Srbija
#4
Za pocetak imam samo ovo, jedan hot-end i dva mehanizma bez stepera …
Od mehanike fali motor, konstrukciju imam, trebam nosac samo prilagoditi za ovu plastiku.
Onda elektronika, ima 4 ose, 1-2 termo in, 1-2 out, i to da ide na PC. Kontroler od Arduino do FPGA zavisi sta su zahtevi.

Kada se uspostavi veza izmedju PC i kontrolera odatle na dalje je sve G-CODE ...

[Image: attachment.php?aid=21701]
Reply


Messages In This Thread
3D printing - Srbija - by vsavic - 12-03-2016, 08:12 PM
RE: 3D printing - Srbija - by Bocko - 12-04-2016, 10:18 AM
RE: 3D printing - Srbija - by TDA - 12-04-2016, 05:27 PM
RE: 3D printing - Srbija - by mikikg - 12-04-2016, 06:50 PM
RE: 3D printing - Srbija - by mikikg - 12-04-2016, 07:24 PM
RE: 3D printing - Srbija - by mikikg - 01-28-2019, 04:59 PM
RE: 3D printing - Srbija - by mikikg - 01-28-2019, 05:12 PM
RE: 3D printing - Srbija - by vsavic - 01-28-2019, 06:09 PM
RE: 3D printing - Srbija - by mikikg - 01-28-2019, 07:58 PM
RE: 3D printing - Srbija - by vsavic - 01-28-2019, 08:12 PM
RE: 3D printing - Srbija - by mikikg - 01-28-2019, 08:24 PM
RE: 3D printing - Srbija - by vsavic - 01-28-2019, 08:37 PM
RE: 3D printing - Srbija - by mikikg - 01-28-2019, 08:46 PM
RE: 3D printing - Srbija - by vsavic - 01-28-2019, 09:09 PM
RE: 3D printing - Srbija - by mikikg - 01-28-2019, 10:11 PM
RE: 3D printing - Srbija - by Makso - 01-29-2019, 12:26 AM
RE: 3D printing - Srbija - by gimba - 01-29-2019, 12:44 AM
RE: 3D printing - Srbija - by mikikg - 01-29-2019, 11:46 AM
RE: 3D printing - Srbija - by euronymous - 01-29-2019, 12:11 PM
RE: 3D printing - Srbija - by me[R]a - 02-01-2019, 09:42 PM
RE: 3D printing - Srbija - by nik - 02-01-2019, 10:09 PM

Forum Jump:


Users browsing this thread: 3 Guest(s)