Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Uradi sam- fluks pasta
#10
Ne treba meni za zaštitu PCB nego pasta za lemljenje.
Da bocnem žičicu pre nego je kalajišem, da nanesem negde malo a da ne procuri i tako.
Nešto kao ona iz tube samo čistija.
Ne volim da se tečnosti vuku po stolu dok radim jer sam nepažljiv i brzoplet.
I can't be sorry, if I ain't always a saint
Like to be a nice guy, but don't blame me if I ain't
Reply


Messages In This Thread
Uradi sam- fluks pasta - by acivoj - 05-13-2014, 02:30 PM
RE: Uradi sam- fluks pasta - by Marshall - 05-13-2014, 02:57 PM
RE: Uradi sam- fluks pasta - by HSP - 05-13-2014, 03:17 PM
RE: Uradi sam- fluks pasta - by TDA - 05-13-2014, 03:40 PM
RE: Uradi sam- fluks pasta - by acivoj - 05-13-2014, 03:44 PM
RE: Uradi sam- fluks pasta - by TDA - 05-13-2014, 04:02 PM
RE: Uradi sam- fluks pasta - by acivoj - 05-13-2014, 04:18 PM
RE: Uradi sam- fluks pasta - by Marshall - 05-13-2014, 04:46 PM
RE: Uradi sam- fluks pasta - by acivoj - 05-13-2014, 05:01 PM
RE: Uradi sam- fluks pasta - by Marshall - 05-13-2014, 05:08 PM
RE: Uradi sam- fluks pasta - by Dragan83 - 02-12-2024, 11:28 AM
RE: Uradi sam- fluks pasta - by savan - 02-12-2024, 01:47 PM
RE: Uradi sam- fluks pasta - by gorso69 - 02-13-2024, 12:02 AM
RE: Uradi sam- fluks pasta - by Dragan83 - 02-13-2024, 01:27 PM
RE: Uradi sam- fluks pasta - by savan - 02-13-2024, 02:13 PM
RE: Uradi sam- fluks pasta - by veselinovic - 02-14-2024, 07:19 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)