|
KiCad
|
03-26-2026, 02:09 PM
Ja koristim EAGLE 7.5,zadnju verziju prije nego su se prodali autodesku i još uvijek ne mislim preći na nešto novoga. Generiranje gerbera u njemu je po meni mačji kašalj. Koristim nekakav gerber job file kojeg je Mikikg postavio davnih dana i radi bez problema sa jlcpcbom. Nikakvo logiranje nije potrebno i sve radi bez ikakvih problema.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
RE: KiCad 5 - by Boban - 02-13-2026, 08:25 PM
RE: KiCad 5 - by Ubledeli - 02-13-2026, 11:15 PM
RE: KiCad 5 - by Boban - 02-13-2026, 11:36 PM
RE: KiCad 5 - by Ubledeli - 02-14-2026, 01:00 PM
RE: KiCad 5 - by Boban - 02-28-2026, 02:14 PM
RE: KiCad 5 - by Boban - 02-17-2026, 09:58 AM
RE: KiCad 5 - by Boban - 03-25-2026, 05:17 PM
RE: KiCad 5 - by mikikg - 03-25-2026, 06:21 PM
RE: KiCad 5 - by ZASto - 03-26-2026, 01:45 PM
RE: KiCad 5 - by Miladin - 03-25-2026, 06:33 PM
RE: KiCad 5 - by Boban - 03-26-2026, 02:02 PM
RE: KiCad 5 - by ZASto - 03-26-2026, 02:47 PM
RE: KiCad 5 - by Khadgar2007 - 03-26-2026, 02:09 PM
|
