Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
3D printing - Srbija
#21
Odlicno je i ovako. Jedino bih umesto gumice za podizanje stavio oprugu ili dve recimo, sa plocicom koja ih spaja a ispod nosaca kuda ide gumica.
Inace negde sam video i ideju da se koristi konstrukcija nosaca lasera od neispravnih CD/DVD drajva za PC.
Reply


Messages In This Thread
3D printing - Srbija - by vsavic - 12-03-2016, 08:12 PM
RE: 3D printing - Srbija - by Bocko - 12-04-2016, 10:18 AM
RE: 3D printing - Srbija - by TDA - 12-04-2016, 05:27 PM
RE: 3D printing - Srbija - by mikikg - 12-04-2016, 06:50 PM
RE: 3D printing - Srbija - by mikikg - 12-04-2016, 07:24 PM
RE: 3D printing - Srbija - by mikikg - 01-28-2019, 04:59 PM
RE: 3D printing - Srbija - by mikikg - 01-28-2019, 05:12 PM
RE: 3D printing - Srbija - by vsavic - 01-28-2019, 06:09 PM
RE: 3D printing - Srbija - by mikikg - 01-28-2019, 07:58 PM
RE: 3D printing - Srbija - by vsavic - 01-28-2019, 08:12 PM
RE: 3D printing - Srbija - by mikikg - 01-28-2019, 08:24 PM
RE: 3D printing - Srbija - by vsavic - 01-28-2019, 08:37 PM
RE: 3D printing - Srbija - by mikikg - 01-28-2019, 08:46 PM
RE: 3D printing - Srbija - by vsavic - 01-28-2019, 09:09 PM
RE: 3D printing - Srbija - by mikikg - 01-28-2019, 10:11 PM
RE: 3D printing - Srbija - by Makso - 01-29-2019, 12:26 AM
RE: 3D printing - Srbija - by gimba - 01-29-2019, 12:44 AM
RE: 3D printing - Srbija - by mikikg - 01-29-2019, 11:46 AM
RE: 3D printing - Srbija - by euronymous - 01-29-2019, 12:11 PM
RE: 3D printing - Srbija - by me[R]a - 02-01-2019, 09:42 PM
RE: 3D printing - Srbija - by nik - 02-01-2019, 10:09 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)